To start we will assume that you have disassembled the console down to the main motherboard. Lay the RetroGlow pcb over top of the console and align the points.
STEP 1. We recommend securing the board down with some kapton tape to stop it from moving around too much while soldering.
STEP 2. Next apply some flux and begin soldering. All the points highlighted in red will need to be soldered. If you are adding and IPS screen, you can solder the brightness button to the point labeled BRGHT.
STEP 3. You can test if it works by placing the battery against the contacts on the back of the console before reassembly.
STEP 4. If all the leds turn on then you can proceed onto final reassembly! ù
STEP 5. If all the lights turn on, then proceed onto final reassembly.
STEP 5. If all the lights turn on, then proceed onto final reassembly.
MODE SELECTION
You can cycle through several modes in this kit. Navigation through the menus is done by holding Select and pressing Left or Right. You will know you’ve entered a menu when you see the LEDs blink twice. Here are the different menu options with their respective controls, in order:
COLOR MODE EDIT
In Color Mode Edit, the controls and options will change depending on which color mode you have selected. See the table below for descriptions of each mode and the different customization options available.